How do I get good stance on an Aoshima 1/24 RX7 Fd3s model? Try this.
FRONT:
simply remove the spacer from the top suspension A-arm
glue the spacer to the lower suspension arm.
Carefully cut this piece off.
Somply glue the removed piece to the bottom.
REAR:
remove around two coils from the suspension to cater for the drop
remove the chassis mounts so the subframe can sit flat
You can see the depth here
to go further.
reshape the wheel hub to allow for a further drop in ride height.
You can see the hub sits below the suspension arm.
No comments:
Post a Comment